![]() ![]() Screw the T-10 Torx Screws to connect the units.Test that the key maintains its full range of motion.Press the key latch box flush against the box.Insert the red button tabs with the housing in the key latch box.Insert the spring into the Key Latch Box in the circle that holds it.Lastly, When putting the unit back together. The two tabs on the red button are positioned properly (Green Arrows).The red button has the spring inside of it in the center (Purple Arrow).The handle circles are in their holes (orange arrow).The silver post is inside the nylon hoop (yellow arrow).When putting the mechanism back together, make sure that: Key Latch Backside Inside of Key Latch Box They can be sanded or Dremeled slightly to allow them to pass freely by each other. ![]() Yakima Racks can stand up to practically anything. If the key has regained full motion, these parts running into each other are most likely the cause. 11 cubic feet cargo capacity (89' x 24' x 15') Cargo net can help keep your cargo in place for your trip, sold separately Quick assembly with no tools required About Yakima The Yakima design has always been about functionality and durability. First, check that the key has returned to a full range of motion when the Key Latch box is removed from the system. During this movement along the drive bar, the top of the hoop (with the hole and silver bar in it) can make contact with the inside of the black box).Ĥ) To eliminate this contact: remove the Key Latch Box by removing all 3 Torx Screws and sliding the Key Latch box to the side of the working components. Unlocking this mechanism slides the black piece of nylon behind the button, allowing the button to pivot the silver drive bar. When re-tightening the screws, make sure not to overtighten, as this can flex the plastic and cause the issue to re-occur. ![]() This should lift one of the parts out of the way. Best Overall Rooftop Box Yakima GrandTour 16 879 at REI 75 OVERALL SCORE Ease of Use 8.0 Security 7.0 Quality 7.0 Appearance 8. There are 3 boltsįirst, try loosening these bolts, lifting the black box on the drive bar with the outer handle mechanism and re-tightening the screws.
0 Comments
Leave a Reply. |